Samsung M262x Benutzerhandbuch (en)

Herunterladen
Wireless network setup
132
2.  Using a Network-Connected Machine
 
Enter the wireless Network Name: Enter the SSID name you want (SSID 
is case-sensitive).
Operation Mode: Select ad hoc.
Channel: Select the channel. (Auto Setting or 2412 MHz to 2467 MHz).
Authentication: Select an authentication type.
Open System: Authentication is not used, and encryption may or may 
not be used, depending on the need for data security.
Shared Key: Authentication is used. A device that has a proper WEP key 
can access the network.
Encryption: Select the encryption (None, WEP64, WEP128).
Network Password: Enter the encryption network password value.
Confirm Network Password: Confirm the encryption network 
password value.
WEP Key Index: If you are using WEP Encryption, select the appropriate 
WEP Key Index.
The wireless network security window appears when the ad hoc network 
has security enabled.
Select Open System or Shared Key for the authentication and click Next.
WEP (Wired Equivalent Privacy) is a security protocol preventing 
unauthorized access to your wireless network. WEP encrypts the data 
portion of each packet exchanged on a wireless network using a 64-bit 
or 128-bit WEP encryption key.
 
The window showing the wireless network setting appears. Check the 
settings and click Next.
 
Before entering the IP address for the machine, you must know the 
computer’s network configuration information. If the computer’s network 
configuration is set to DHCP, the wireless network setting should also be 
DHCP. Likewise, if the computer’s network configuration is set to Static, the 
wireless network setting should also be Static.
If your computer is set to DHCP and you want to use the Static wireless 
network setting, you must contact the network administrator to get the 
static IP address.
For the DHCP method
If the IP address assignment method is DHCP, check if DHCP is shown in 
the Wireless Network Setting Confirm window. If it shows Static, click 
Change TCP/IP to change the assignment method to Receive IP 
address automatically (DHCP)
.
For the Static method
If the IP address assignment method is Static, check if Static is shown in 
the Wireless Network Setting Confirm window. If it shows DHCP, click 
Change TCP/IP to enter the IP address and other network configuration 
values for the machine.
For example,
If the computer’s network information is as shown follows:
-
IP address: 169.254.133.42
-
Subnet Mask: 255.255.0.0
Then, the machine’s network information should be as below:
-
IP address: 169.254.133.43
-
Subnet Mask: 255.255.0.0 (Use the computer’s subnet mask.)
-
Gateway: 169.254.133.1