Samsung M262x Benutzerhandbuch (en)

Regulatory information
5. Appendix
United States of America
Federal communications commission (FCC)
Intentional emitter per FCC Part 15
Low power, Radio LAN type devices (radio frequency (RF) wireless 
communication devices), operating in the 2.4 GHz/5 GHz Band, may be present 
(embedded) in your printer system. This section is only applicable if these 
devices are present. Refer to the system label to verify the presence of wireless 
Wireless devices that may be in your system are only qualified for use in the 
United States of America if an FCC ID number is on the system label.
The FCC has set a general guideline of 20 cm (8 inches) separation between the 
device and the body, for use of a wireless device near the body (this does not 
include extremities). This device should be used more than 20 cm (8 inches) 
from the body when wireless devices are on. The power output of the wireless 
device (or devices), which may be embedded in your printer, is well below the 
RF exposure limits as set by the FCC.
This transmitter must not be collocated or operation in conjunction with any 
other antenna or transmitter.
Operation of this device is subject to the following two conditions: (1) This 
device may not cause harmful interference, and (2) this device must accept any 
interference received, including interference that may cause undesired 
operation of the device.
Wireless devices are not user serviceable. Do not modify them in any way. 
Modification to a wireless device will void the authorization to use it. 
Contact manufacturer for service.
FCC statement for wireless LAN use:
While installing and operating this transmitter and antenna combination 
the radio frequency exposure limit of 1m W/cm2 may be exceeded at 
distances close to the antenna installed. Therefore, the user must maintain 
a minimum distance of 20cm from the antenna at all times. This device 
cannot be collocated with another transmitter and transmitting antenna.
Russia/Kazakhstan/Belaru only