Canon sx260hs User Manual (en)
Using an Eye-Fi Card
217
Check the access point SSID used by the Eye-Fi card or the connection
status, as needed.
status, as needed.
z
Press the
n button, choose [Eye-Fi
Settings] on the
3 tab, and then press the
m button.
z
Choose [Connection info], and then press the
m button.
m button.
X
The connection information screen is
displayed.
displayed.
Configure the setting as follows to disable Eye-Fi transfer by the card, if
necessary.
necessary.
Choose [Disable] in [Eye-Fi trans.].
z
Press the
n button, choose [Eye-Fi
Settings] on the
3 tab, and then press the
m button.
z
Choose [Eye-Fi trans.], and then choose
[Disable].
[Disable].
•
Power saving (p. 36) on the camera is temporarily disabled during image
transfer.
transfer.
•
Choosing
mode will interrupt the Eye-Fi connection. Although the Eye-Fi
connection will be restored after you choose another shooting mode or enter
Playback mode, the camera may transfer any movies made in
Playback mode, the camera may transfer any movies made in
mode again.
Checking Connection Information
Disabling Eye-Fi Transfer
•
[Eye-Fi Settings] is not shown unless an Eye-Fi card is in the camera
with its write-protect tab in the unlocked position. For this reason, you
cannot change settings for an inserted Eye-Fi card if the write-protect
tab is in the locked position.
with its write-protect tab in the unlocked position. For this reason, you
cannot change settings for an inserted Eye-Fi card if the write-protect
tab is in the locked position.
COP
Y