Nikon d3s User Manual (en)

❚❚Canceling Bracketing
To cancel bracketing, press the 
D button and rotate the main 
command dial until the number of shots in the bracketing 
sequence is zero (
) and M is no longer displayed. The program 
last in effect will be restored the next time bracketing is activated. 
Bracketing can also be cancelled by performing a two-button reset 
0 200), although in this case the bracketing program will not be 
restored the next time bracketing is activated.
Exposure and Flash Bracketing
In continuous low speed and continuous high speed modes, shooting 
will pause after the number of shots specified in the bracketing 
program have been taken. Shooting will resume the next time the 
shutter-release button is pressed. In other modes, one shot will be 
taken each time the shutter-release button is pressed.
If the memory card fills before all shots in the sequence have been 
taken, shooting can be resumed from the next shot in the sequence 
after the memory card has been replaced or shots have been deleted to 
make room on the memory card. If the camera is turned off before all 
shots in the sequence have been taken, bracketing will resume from the 
next shot in the sequence when the camera is turned on.
Exposure Bracketing
The camera modifies exposure by varying shutter speed and aperture 
(programmed auto), aperture (shutter-priority auto), or shutter speed 
(aperture-priority auto, manual exposure mode). If On is selected for 
ISO sensitivity settings > ISO sensitivity auto control in modes e, f, 
and g and no flash is attached, the camera will automatically vary ISO 
sensitivity for optimum exposure when the limits of the camera 
exposure system are exceeded. Custom Setting e5 (Auto bracketing 
(mode M)
0 313) can be used to change how the camera performs 
exposure and flash bracketing in manual exposure mode. Bracketing 
can be performed by varying flash level together with shutter speed 
and/or aperture, or by varying flash level alone.