Nikon D800 User Manual (en)

• Remote Cord MC-22: Remote shutter release with blue, yellow, 
and black terminals for connection to a remote shutter-
triggering device, allowing control via sound or electronic 
signals (length 1 m/3 ft 3 in.).
• Remote Cord MC-30: Remote shutter release; can be used to 
reduce camera shake (length 80 cm/2 ft 7 in.).
• Remote Cord MC-36: Remote shutter release; can be used for 
interval timer photography or to reduce camera shake or 
keep the shutter open during a time exposure (length 
85 cm/2 ft 9 in.).
• Extension Cord MC-21: Can be connected to ML-3 or MC-series 
20, 22, 23, 25, 30, or 36. Only one MC-21 can be used at a 
time (length 3 m/9 ft 10 in.).
• Connecting Cord MC-23: Connects two cameras for 
simultaneous operation (length 40 cm/1 ft 4 in.).
• Adapter Cord MC-25: Ten-pin to two-pin adapter cord for 
connection to devices with two-pin terminals, including 
the MW-2 radio control set, MT-2 intervalometer, and 
ML-2 modulite control set (length 20 cm/8 in.).
• GPS Unit GP-1 (
0 215): Record latitude, longitude, altitude, 
and UTC time with pictures.
• GPS Adapter Cord MC-35 (
0 215): This 35 cm (1 ft 2 in.) cable 
connects the camera to older GARMIN eTrex- and geko-
series GPS units that conform to version 2.01 or 3.01 of the 
National Marine Electronics Association NMEA0183 data 
format. Only models that support PC interface cable 
connections are supported; the MC-35 can not be used to 
connect GPS units via USB. The units connect to the 
MC-35 using a cable with a D-sub 9-pin connector 
provided by the manufacturer of the GPS device; see the 
MC-35 instruction manual for details. Before turning the 
camera on, set the GPS device to NMEA mode 
(4800 baud); for more information, see the 
documentation provided with the GPS device.
• Modulite Remote Control Set ML-3: Allows infrared remote 
control at ranges of up to 8 m (26 ft 3 in.).