Nikon KeyMission 360 Quick Setup Guide (en)

Download
12
Getting Started
Re-pairing
Perform re-pairing in the following situations:
• When pairing the same smart device again after unpairing using End pairing in 
the SnapBridge 360/170 app
• When pairing with a second smart device or more
1
Prepare for pairing (
2
Press and hold down the movie button 
for about 7 seconds to put the camera 
into pairing standby mode.
• When the status lamps flash green at the same 
time for a while and then alternately flash green, 
the camera enters pairing standby mode.
• If the camera cannot find the smart device, the 
camera turns off automatically after remaining in 
pairing standby mode for about 4 minutes.
3
Start pairing.
• For iOS or NFC-incompatible Android devices:
Start the SnapBridge 360/170 app.
• For NFC-compatible Android devices:
Tap the NFC antenna of the smart device to the 
Y (N-Mark) on the camera to start the 
SnapBridge 360/170 app.
When Camera name acquired. Connect? is 
displayed, select OK and proceed to step 5.
If the SnapBridge 360/170 app download site is 
displayed on the smart device screen, repeat this 
operation after installation.
Status lamps