Canon EOS-1D X Manual (en)

Connecting the Camera and Computer
To download to your computer images shot with your camera, you will 
need to connect your camera and computer using the interface cable 
provided with the camera.
Connect the large plug of the cable into the USB port 
of your computer.
For the location and direction of the USB port, refer to the user’s 
manual for the computer.
Connect the small plug of the cable into the terminal 
on your camera.
Once the plug is connected to the camera according to the steps 
for your camera model, preparation for downloading images is 
complete. Refer to “
 Confirming Computer Settings” to check 
the settings of the computer, and continue with “Starting up EU” 
With the <
> mark on the plug facing the front of the camera, 
connect it to the camera’s <A/V OUT / DIGITAL> terminal.
Confirming Computer Settings
Before you start up EU, connect the camera and the computer 
and set the camera’s power switch to <ON>, then make sure that 
the following settings are applied to your computer. If these are 
not applied, adjust the settings as follows. Internet connection is 
Windows 7
Select [Control Panel]  [Devices and Printers].  Double-
click the icon of the camera connected to the computer.  
Double-click [Change general settings] in the menu that 
appears.  Set the pull-down menu for [When this device 
connects to this computer] to [Take no action].
Windows 8.1/Windows 8
Select [Control Panel]  [View devices and printers].  
Double-click the icon of the camera connected to the 
computer.  Select and double-click [Change general 
settings] in the menu that appears.  Set the pull-down menu 
for [When this device connects to this PC] to [Take no action].
After confirming and adjusting the settings, set the camera’s 
power switch to <OFF>.
To start up EU, you must connect your camera to the same USB 
port as when you confirmed and adjusted the settings.
To use another USB port, confirm and adjust the settings again.
, you can fix the plug to the camera with 
the cable protector to prevent the plug from disconnecting. For 
details on using, se
1D X
1D C