Canon EOS-1D X Manual (en)

Download
66
Editing with the Trimming/Angle Adjustment Tool Palette
You can crop only the part of an image you need, or change the 
composition of an image where an image shot horizontally becomes 
vertical. You can also adjust the angle of an image before cropping.
1
Select the image to be cropped.
2
Display the Trimming/Angle Adjustment tool palette.
You cannot make adjustments with the Trimming/Angle 
Adjustment tool palette in a window that only shows thumbnails.
3
Adjust the angle of the image as needed.
Trimming/angle adjustment window
Use the mouse (click /) to adjust the angle or directly enter 
the adjustment angle (0.01-degree increments; adjustable 
range: –45 to +45 degrees)
Drag (0.01-degree increments; adjustment range: –45 to +45 
degrees)
Largest possible 
trimming range
If you click [Center on Screen], you can display the trimming 
range in the center of the window.
When correcting lens aberrations, it is recommended to perform 
lens aberration correction before adjusting the angle of the 
image.
If you have only adjusted the angle of the image, the image will 
be cropped at the largest possible trimming range.
4
Select a ratio and drag the trimming range.
The trimming range can be moved by dragging.
You can enlarge or reduce the size of the trimming range by 
dragging the four corners of the trimming range. 
Cancel
Select a trimming ratio
Drag the trimming 
range
When aspect ratio information is attached to an image shot with any 
supported camera other than the EOS 5D Mark II, the displayed 
trimming range is based on the aspect ratio information.
JPEG/TIFF