Olympus fe-300 Introduction Manual (en)

Download
48 
EN
Getting to know your camera better
When you get an error message on the camera...
Monitor indication
Possible cause
Corrective action
q
CARD ERROR
There is a problem with the 
card.
This card cannot be used. Insert a new card.
q
WRITE PROTECT
Writing to the card is 
prohibited.
The recorded image has been protected 
(read-only) on a computer. Download the 
image to a computer and cancel the read-
only setting.
>
MEMORY FULL
The internal memory has no 
available memory and 
cannot store any new data.
Insert a card or erase unwanted data. Before 
erasing, backup the data of important 
pictures using the card, or download such 
pictures to a computer.
q
CARD FULL
The card has no available 
memory and cannot store 
any new data.
Replace the card or erase unwanted data. 
Before erasing, download important pictures 
to a computer.
L
NO PICTURE
There are no pictures in the 
internal memory or on the 
card.
The internal memory or the card contains no 
pictures.
Record pictures.
r
PICTURE ERROR
There is a problem with the 
selected picture and it 
cannot be played back on 
this camera.
Use image processing software to view the 
picture on a computer. If that cannot be 
done, the image file is damaged.
r
THE IMAGE 
CANNOT BE 
EDITED
Pictures taken by other 
cameras or previously 
edited or corrected pictures 
cannot be edited or fixed.
Use image processing software to edit the 
pictures.
CARD-COVER 
OPEN
The battery/card 
compartment cover is open.
Close the battery/card compartment cover.
g
BATTERY EMPTY
The battery is empty.
Charge the battery.
The data in the card cannot 
be read. Or, the card is not 
formatted.
• Select [xD CARD CLEAN], and press 
. 
Remove the card and wipe the contact 
area with a soft dry cloth.
• Select [FORMAT]
[YES] and press 
. 
All data on the card is erased.
There is an error in the 
internal memory.
Select [MEMORY FORMAT] 
[YES] and 
press 
. All data in the internal memory is 
erased.
NO CONNECTION
The camera is not 
connected to the computer 
or the printer correctly.
Disconnect the camera and connect it again 
correctly.
NO PAPER
There is no paper in the 
printer.
Load some paper into the printer.
NO INK
The printer has run out of 
ink.
Replace the ink cartridge in the printer.
OK
C A R D   S E T U P
xD CARD CLEAN
FORMAT
SET
OK
M E M O R Y   S E T U P
POWER OFF
MEMORY FORMAT
SET
d4349_33_e_0000_7.book  Page 48  Thursday, June 28, 2007  4:47 PM