Olympus fe-300 Introduction Manual (en)

All rights reserved. No part of these written materials or this software may be reproduced or used in 
any form or by any means, electronic or mechanical, including photocopying and recording or the use 
of any type of information storage and retrieval system, without the prior written permission of 
Olympus. No liability is assumed with respect to the use of the information contained in these written 
materials or software, or for damages resulting from the use of the information contained therein. 
Olympus reserves the right to alter the features and contents of this publication or software without 
obligation or advance notice.
• Radio and Television Interference
Changes or modifications not expressly approved by the manufacturer may void the user’s authority 
to operate this equipment. This equipment has been tested and found to comply with the limits for 
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide 
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:
- Adjust or relocate the receiving antenna.
- Increase the distance between the camera and receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is 
- Consult your dealer or an experienced radio/TV technician for help. Only the OLYMPUS-supplied 
USB cable should be used to connect the camera to USB enabled personal computers (PC).
Any unauthorized changes or modifications to this equipment would void the user’s authority to 
For customers in USA
Declaration of Conformity
Model Number
: FE-300/X-830
Trade Name
Responsible Party :
: 3500 Corporate Parkway, P.O. Box 610, Center Valley,
PA 18034-0610, U.S.A.
Telephone Number: 484-896-5000
Tested To Comply With FCC Standards
This device complies with Part 15 of the FCC rules. Operation is subject to the following 
two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may 
cause undesired operation.
For customers in Canada
This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
Copyright Notice
FCC Notice
For customers in North and South America
d4349_33_e_0000_7.book  Page 58  Thursday, June 28, 2007  4:47 PM