Netgear R6900 - Nighthawk AC1900 Smart WiFi Router User Manual (en)

Select ADVANCED > Setup > LAN Setup.
The LAN Setup page displays.
From the RIP Direction menu, select an RIP direction:
Both. The router broadcasts its routing table periodically and incorporates information that it receives. This
is the default setting.
Out Only. The router broadcasts its routing table periodically but does not incorporate the RIP information
that it receives.
In Only. The router incorporates the RIP information that it receives but does not broadcast its routing table.
From the RIP Version menu, select an RIP version:
Disabled. The RIP version is disabled. This is the default setting.
RIP-1. This format is universally supported. It is adequate for most networks, unless you are using an unusual
network setup.
RIP-2. This format carries more information. Both RIP-2B and RIP-2M send the routing data in RIP-2 format.
RIP-2B uses subnet broadcasting. RIP-2M uses multicasting.
Click the Apply button.
Your settings are saved.
Manage the DHCP Server Address Pool
By default, the router acts as a Dynamic Host Configuration Protocol (DHCP) server. The router assigns IP, DNS
server, and default gateway addresses to all computers that are connected to its LAN and WiFi network. The assigned
default gateway address is the LAN address of the router.
These addresses must be part of the same IP address subnet as the router’s LAN IP address. The default DHCP
address pool is–
The router delivers the following parameters to any LAN device that requests DHCP:
An IP address from the range that you define
Subnet mask
Gateway IP address (the router’s LAN IP address)
DNS server IP address (the router’s LAN IP address)
To specify the pool of IP addresses that the router assigns:
Launch a web browser from a computer or WiFi device that is connected to the network.
A login window opens.
Enter the router user name and password.
Manage the WAN and LAN Network Settings
Nighthawk AC1900 Smart WiFi Router Model R6900