Olympus Stylus 410 Digital Introduction Manual (en)

Download
          
PREPARING THE CAMERA FOR USE
Before you begin using your Olympus Digital Camera…
a.
Charging the battery
The Digital Camera uses an Olympus Lithium ion battery (LI-10B) and dedicated charger (LI-
10C). This is the only battery/charger designed for use with the Digital Camera. The battery 
cannot be charged while in the camera. 
Note: The Lithium ion battery is not fully charged when the camera is 
purchased. You must fully charge the battery using the charger before first use.
• Insert the Lithium ion battery into the charger as indicated in the illustration.
• Connect the battery charger AC cable as shown to a standard wall outlet.
• To fully charge the battery requires approximately 2 hours. The charge indicator light will be red 
when charging, and will turn green when the charging process is complete.
b.
Loading the battery
Note: The battery and xD-Picture card compartments are accessed by opening the 
respective compartment covers.
• Slide the battery compartment cover in the direction of the arrow, and lift 
open the cover as shown in the illustration. (the direction indicated by the 
 mark on the cover)
• Insert the battery into the compartment.
• Close the battery compartment cover so that it pushes the battery in and 
slide the cover while pressing the 
 mark.
Note: If the battery compartment cover is hard to close, do 
not force it. Press 
 on the cover firmly to close the cover, 
and then slide it into position.
• To remove the battery, make sure that the monitor and the lamp at the 
side of the viewfinder are off. Return the camera to the upright position 
and tip the battery out. 
c.
Inserting the xD-Picture Card
The xD-Picture Card is where the camera stores your pictures and 
is available in a variety of memory capacities. The pictures you take 
with the camera remain on the xD-Picture Card even when the 
camera is turned off and/or the battery is removed.
• Open the connector cover while pressing the   mark as in the illustration.
• Open the card cover by pulling the card cover catch towards you.
• Insert the xD-Picture Card into the spring-loaded card slot as shown in 
the illustration. Push the card fully into the slot. The card will lock into 
place when fully inserted.
• To remove, push the card all the way in to unlock it, then let it return slowly.
• Close the card cover before closing the connector cover.
• Press   to close the connector cover.
Confirm you have installed the battery and xD-Picture Card properly by 
pressing 
. The “NO PICTURE” message should be displayed in the 
monitor. Turn the camera off by pressing 
 again.
d.
Attaching the strap 
(OPTIONAL)
Attach the strap as illustrated to make the camera easier to handle.
Charge indicator
TURNING ON THE CAMERA
All you need to do is slide the lens barrier open or close to turn the camera ON or OFF.
a.
Turning the camera ON 
(SHOOTING MODE)
• Slide the lens barrier fully until it clicks. The lens extends.
• To turn the camera off, slide the lens barrier until you feel the first click. Wait until the lens is fully retracted, then 
close the lens barrier all the way.
:To maximize battery life, the Digital Camera features a power saving mode in which the camera enters a sleep mode after 
approximately three (3) minutes of non-use. Press the shutter button to wake up the camera.
b.
Setting the Date and Time 
(OPTIONAL)
Set the date and time when using the camera for the first time. This affects the way image file names are 
created, and will conveniently include this information with each picture. 
• With the front lens barrier closed, press 
 once. The monitor will turn on with “NO PICTURE” displayed in the 
monitor. (The date and time can also be set when the camera is in the shooting mode.)
• Press 
 to display the top menu.
• Press   to select MODE MENU.
• Press 
 to select SETUP, and then press  .
• Press 
 to select 
, and then press  .
• Use 
 to select the date format.
• Adjust the date and time in the appropriate fields by using   to select the field, and 
 to set the proper value. 
Repeat this step until all date/time fields have been set.
Note: Time is entered using the 24-hour format.
• Press 
 to store the date and time.
c.
Camera Diagram and Controls
Now take a moment to familiarize yourself with the key areas of camera controls by reviewing the illustrations.
Power on
Power off
TIP
VIDEO OUT 
jack
Card cover catch
Self-timer/
Remote control lamp
Flash
Remote control 
receiver
USB 
connector
Connector 
cover
Lens barrier
Lens
DC-IN jack
DC-IN jack 
cover
Card cover
Printed in China
UNPACKING THE BOX CONTENTS
Gather your Digital Camera and the parts as shown in the illustration. You’ll need these to complete the steps for the camera 
set-up procedures that follow.
Camera Settings in Shooting Mode as shown in Monitor
Camera Settings in Playback Mode as shown in Monitor
Note: Depending on the camera settings, not all indicators will be displayed.
Viewfinder
Green lamp
Orange lamp
Monitor button (QUICK VIEW 
)
Monitor
OK/Menu button
Tripod socket
Shutter button
Zoom button
Strap eyelet
Battery
component
cover
Arrow pad (
)
 Shooting mode button
 Self-timer button
 Macro button
 Flash mode button
Speaker
HQ
HQ 2272*1704
2272*1704
R
%
Battery level
Green lamp
Flash stand-by
Flash mode
Macro mode
Memory gauge
Shooting mode
Exposure compensation
Recording sound
with still pictures
White balance
Spot metering
Image quality
Number of storable still pictures/
Remaining recording time (movie)
AF target mark
DRIVE
Resolution
Self-timer/Remote control
2272
2272 1704
1704
$04.01.01 15:30
$04.01.01 15:30
H
Battery level
Playback (Recording sound)
Protect
Image quality
Resolution
Exposure compensation
White balance
Date and time
File number (still picture)/
Frame number (still picture/movie)/
Total recording time (movie)
Print reservation (still picture)/
Movie play (playing back movies)
The following items are also included in the Digital Camera package: Basic Manual, A/V cable, RM-2 remote control, warranty card, 
registration card (not provided in some areas).
Digital Camera
Strap
LI-10B lithium 
ion battery
LI-10C
Battery charger
AC cable 
for the battery 
charger
CD-ROM 
(CAMEDIA Master/
Reference Manual)
USB cable
xD-Picture Card
QuickStart Guide
http://www.olympus.com/
VT693501
OLYMPUS AMERICA INC.
Two Corporate Center Drive, Melville, 
NY 11747-3157, U.S.A.
http://www.olympusamerica.com/support
Olympus Europa GmbH
Wendenstrasse 14-18, 
20097 Hamburg, Germany 
http://www.olympus-europa.com/
START HERE
It is strongly recommended that you follow these step-by-step 
numbered instructions to set up and quickly begin using your 
new Digital camera.
For more detailed instructions on advanced features, please refer to 
the printed Basic Manual included in your package, or the Reference 
Manual on the CD-ROM.
d4199_qsge_6.fm  Page 1  Thursday, December 4, 2003  10:29 AM