Canon multipass c3000 Service Manual (en)

Download
"DATA ERROR"
Cause:
The registration data in the SRAM was destroyed and a checksum error
occurred due to a dead lithium battery or SRAM failure.
Solutions:
(1) Press the 
START/COPY
button, and turn the power off and on again.
(2) Replace the lithium battery.
(3) Replace the SCNT board.
"DOC. TOO LONG" (#003)
Cause:
The document is longer than 39.4"(1m).
Solution:
Use a copy machine to make a reduced copy of the document. Then send
again.
Cause:
It took more than 32 minutes to send or copy a document. It took more
than 32 minutes to receive a document.
Solution:
Divide the document and send or copy each part separately. Contact the
other party. Have them divide the document and send each part
separately.
"HANG UP PHONE"
Cause:
The handset or the extension telephone is off the hook.
Solution:
Put the handset or the extension telephone back on the hook.
"PUT IN CARTRIDGE"
Cause:
The BJ cartridge is not set.
Solution:
Set the BJ cartridge.
"MEMORY FULL" (#037)
Cause:
The fax's memory is full because it has received too many documents.
Solutions:
(1)Print out any documents which are stored in memory. Then start
the operation again.
(2)If the memory contains any facsimiles you don't need, delete them.
(3)You cannot receive a fax was scanned with fine graphic images.
Cause:
The fax's memory is full because you tried to send too many pages at
once.
Solution:
Divide the document and send each part separately.
"NO ANSWER" (#005)
Cause:
The receiving fax machine does not answer.
Solution:
Make sure you dialed the correct number. Try again later.
Part 1: Facsimile
3-16