Canon multipass c3000 Service Manual (en)

Download
c) ERROR CORD LIST for MultiPASS C3000
New error codes indicate 
"new"
in this list.
• User error code
No.
Tx or Rx
Definition
#001
[ TX
]
Paper Jam
#003
[ TX/RX ]
Copy Page, Communication Time Over
#005
[ TX/RX ]
Initial ID (T1) Time Over
#009
[ RX
]
Recording Paper Jam or Out of Paper
#011
[ RX
]
Polling Error
#012
[ TX
]
Other party Out of Paper
#018
[ TX/RX ]
Automatic Dialing Error
#021
[ RX
]
DCN during Polling Rx
#022
[ TX
]
Call Failure
#037
[ RX
]
Image Memory Full
#039
[ TX
]
Closed Network Tx Failure
#052
[ RX
]
Image memory full by no ink error
#995
[ TX/RX ]
Memory Communication reservation cancellation
• Service error code
No.
Tx or Rx
Definition
##100
[ TX
]
Excessive Repeat Protocol during Rx
##101
[ TX/RX ]
Modem Speed Different from Other Party
##102
[ TX
]
Fall Back Failure during Tx
##103
[ RX
]
Fail to Detect EOL for 5 Seconds (15 seconds for CBT) during
Rx
##104
[ TX
]
RTN or PIN Received during Tx
##106
[ RX
]
Fail to Receive Protocol for 6 Seconds when Waiting for
Protocol during Rx
##107
[ RX
]
Fall Back Failure on Tx Side during Rx
##109
[ TX
]
Receive Signals Other than DIS, DTC, FTT, CFR or CRP
after DCS Tx and Exceed the Number of Protocol re-
transmissions during Tx
##111
[ TX/RX ]
Memory error
##114
[ RX
]
RTN Transmission during Reception
##200
[ RX
]
Fail to Detect Picture Rx Carrier for 5 Seconds during Rx
##201
[ TX/RX ]
DCN received Other than Normal Binary Protocol
##204
[ TX
]
Receive DTC without Tx Data
##220
[ TX/RX ]
System Error (main program runaway)
##224
[ TX/RX ]
Abnormal Protocol during G3 Communication
##226
[ TX/RX ]
Stack Pointer Not within RAM Range
##229
[ RX
]
Recording Unit Locked for 1 Minute
##232
[ TX
]
ENCODE Control Unit Malfunction
##237
[ RX
]
DECODE Control Unit Malfunction
##238
[ RX
]
PRINT Control Unit Malfunction
##261
[ TX/RX ]
System Error between Modem and SCNT
##280
[ TX
]
Excessive Repeat Protocol Command during Tx
##281
[ TX
]
Excessive Repeat Protocol Command during Tx
##282
[ TX
]
Excessive Repeat Protocol during Tx
Chapter 3: Maintenance & Service
3-21