Canon multipass c3000 Service Manual (en)

Download
#7 PRINTER (printer function settings)
1. SSSW
SW12 (Switch 12: Report frame setting)
Bit
Function
1
0
0
Report frame lines
OFF
ON
1
Report frame line types
Dashed line
Solid line
2
Not used
3
Not used
4
Not used
5
Not used
6
Not used
7
Not used
[Bit 0]
Select whether to draw a frame for printing a report or list.
[Bit 1]
If a frame is drawn for printing a report or list, either a solid line or a dashed line can
be selected.
2. NUMERIC PARAM.
No.
Function
Selecting range
Default setting
12
PRINTER mode 
FAX mode automatic
0 ~ 127
6 ( 60 seconds)
switch-over time in fax reception
(128 ~ 9999: Not used)
[Parameter 12]
When the machine receives a fax in printer mode, it will automatically switch to fax
mode after a specific period of time (as specified using the parameter setting 
×
10 sec.)
for automatic output of the received image –as long as it is not suffering from an error
or is not performing a printer operation. The machine will then switch back to printer
mode after generating the received image.
Specifying "
0
" to the parameter will disable the automatic switch-over (it does not
mean 0 sec.)
3. INK ABSORBER CAPA
This switch allows the waste ink capacity stored in the SCNT board to be checked or entered.
[SUCTION]
This allows the waste ink capacity for the ink absorbed during cleaning to be checked
or entered.
When entering the waste ink capacity, use the numeric buttons to enter a value 0 to
100 (%).
The ink absorber's absorption capacity for the waste ink discharged by the
BJ cartridge is set to a certain amount.  The waste ink capacity settings
are stored in the PCNT board's EEPROM.  When replacing the PCNT
board, check the waste ink capacity and enter the waste ink capacity into
the new PCNT board.
The various waste ink capacity can be checked with the 
SYSTEM DUMP
LIST
.
Part 1: Facsimile
3-42
NOTE