Canon PowerShot SX60 HS Owner's Manual (en)

147

Adjust the timing of automatic camera and screen deactivation (Auto 
Power Down and Display Off, respectively) as needed (

 

●

Choose [Power Saving], and then press 
the [

] button.

 

●

After choosing an item, press the [ ][ ] 
buttons to adjust it as needed.

 

●

To conserve battery power, you should normally choose [On] for 
[Auto Power Down] and [1 min.] or less for [Display Off].

 

●

The [Display Off] setting is applied even if you set [Auto Power 
Down] to [Off].

 

●

These power-saving functions are not available when you have 
set Eco mode (

The lens is normally retracted for safety about one minute after you press 
the [

] button in Shooting mode (

= 25). To have the lens retracted 

immediately after you press the [

] button, set the retraction timing to 

[0 sec.].

 

●

Choose [Lens Retraction], and then 
choose [0 sec.].

This function allows you to conserve battery power in Shooting mode. 

When the camera is not in use, the screen quickly darkens to reduce 
battery consumption. 

 

●

Choose [Eco Mode], and then choose [On].

 

●

[

] is now shown on the shooting 

 

●

The screen darkens when the camera 
is not used for approximately two 
seconds; approximately ten seconds 
after darkening, the screen turns off. 
The camera turns off after approximately 
three minutes of inactivity.

 

●

To activate the screen and prepare for 
shooting when the screen is off but the 
lens is still out, press the shutter button 
halfway.