Pentax K-5 II User Manual (en)

Download
186
Sho
o
ting
 Setti
ngs
6
4
Press the shutter release button fully.
Set the focus mode to \ when the shutter cannot be released.
The screen to select the measuring range is displayed.
5
Use the rear e-dial (S) to select 
the entire screen or spot area for 
the measuring range.
6
When a spot area is selected, use the four-way controller 
(
2345) to move the frame to the position you want to 
measure.
7
Press the 4 button.
The white balance is measured, and the screen that was displayed in 
Step 3 appears again. 
Adjust the white balance as necessary. 
The message [The operation could not be completed correctly] appears 
when measuring is unsuccessful. Press the 4 button to remeasure the 
white balance. 
8
Press the 4 button twice.
The camera is ready to take a picture.
• If a picture is extremely overexposed or underexposed, the white balance 
may not be adjusted. In this case, adjust exposure to the correct amount level 
before adjusting the white balance.
• When the mode dial is set to C (Movie), the white balance cannot be 
measured. Adjust the white balance in any exposure mode other than C 
before recording a movie.
Cancel
OK
OK
MENU
1
1