Canon EOS60D18135ISKIT User Manual (en)

If a problem occurs with the camera, first refer to this Troubleshooting 
Guide. If this Troubleshooting Guide does not resolve the problem, 
contact your dealer or nearest Canon Service Center.
If the battery’s remaining capacity (p.268) is 94% or higher, the battery 
will not be recharged.
Do not recharge any battery pack other than genuine Canon Battery Pack LP-E6.
If there is a problem with the battery charger or battery pack or if 
communication with the battery pack (non-Canon battery packs) is not 
possible, the protective circuit will terminate the charging and the orange 
lamp will blink quickly at a regular interval. If there is a problem with the 
battery charger or battery pack, unplug the charger’s power plug from the 
power outlet. Detach and reattach the battery pack to the charger. Wait 2 
to 3 minutes, then reconnect the power plug to the power outlet. If the 
problem persists, contact your dealer or nearest Canon Service Center.
If the internal temperature of the battery pack attached to the charger is 
high, the charger will not charge the battery for safety reasons (lamp 
off). During the charging, if the battery’s temperature becomes high for 
any reason, the charging will stop automatically (lamp blinks). When the 
battery temperature goes down, the charging will resume automatically.
The battery is not properly installed in the camera (p.26).
Recharge the battery (p.24).
Make sure the battery compartment cover is closed (p.26).
Make sure the card slot cover is closed (p.32).
Troubleshooting Guide
Power-Related Problems
The battery pack does not recharge.
The charger’s lamp blinks at high speed.
The charger’s lamp does not blink.
The camera does not operate even when the power switch is set to <1>.