Canon EOS60D18135ISKIT User Manual (en)

Download
55
1 Fully Automatic Shooting
 
The focus confirmation light <o> blinks and focus is not achieved.
Aim the AF point over an area having good contrast, then press the 
shutter button halfway (p.80). If you are too close to the subject, move 
away and try again.
 
Sometimes multiple AF points flash simultaneously.
This indicates that focus has been achieved at all those AF points. As long as 
the AF point covering the desired subject flashes, you can take the picture.
 
The beeper continues to beep softly. (The focus confirmation 
light <
o> does not light.)
It indicates that the camera is focusing continuously on a moving subject. 
(The focus confirmation light <o> does not light.) You can shoot a 
moving subject in focus.
 
Pressing the shutter button halfway does not focus the subject.
If the focus mode switch on the lens is set to <MF> (Manual Focus), set it 
to <AF> (Auto Focus).
 
Although it is daylight, the flash popped up.
For a backlit subject, the flash may pop up to help lighten the subject’s 
dark areas.
 
In low light, the built-in flash fired a series of flashes.
Pressing the shutter button halfway may trigger the built-in flash to fire a 
series of flashes to assist autofocusing. This is called the AF-assist 
beam. It is effective up to approx. 4 meters/13.1 feet away.
 
Although flash was used, the picture came out dark.
The subject was too far away. The subject should be within 5 meters/16.4 
feet from the camera.
 
When flash was used, the bottom part of the picture came out 
unnaturally dark.
The subject was too close to the camera, and a shadow was created by the lens 
barrel. The subject should be at least 1 meter/3.3 feet away from the camera. If a 
hood has been attached to the lens, remove it before taking the flash picture.
FAQ
COP
Y