Panasonic DMC-FX12 User Manual (en)

Download
Connecting to other equipment
82
VQT1C14
• The drive is displayed as [NO_NAME] or 
[Untitled] when you connect the camera 
with a card inserted.
∫ About motion picture playback on a PC
Use the software “QuickTime” 
(for Windows 2000/XP) in the CD-ROM 
(supplied) to play back motion pictures 
recorded on this camera on a PC.
• If you use “Windows 98/98SE/Me”, 
download “QuickTime 6.5.2 for PC” from 
the following site, and install it.
http://www.apple.com/support/quicktime/
• This software is installed as standard on a 
“Macintosh OS”.
∫ Folder Composition
Folders are displayed as shown in the 
following illustration.
1 Folder number
2 File number
3 JPG: pictures
MOV: motion pictures
MISC: Folder containing files on which the 
DPOF print settings are recorded
• The data for up to 999 pictures recorded 
by the camera can be included in 1 folder. 
If the number of pictures exceeds 999, 
another folder is created.
• To reset the file number or the folder 
number, select [NO.RESET] in the 
[SETUP] menu. (P20)
∫ Conditions under which a different 
folder number is used
In the following cases, the picture is not 
recorded in the same folder as the 
previously recorded picture. It is recorded 
in a folder with a new number. 
When the folder just recorded to contains 
a picture file with the number 999 in it 
(example: P1000999.JPG).
When the card just recorded to contains, 
for example, a folder with the number 
100 [100_PANA] in it and that card is 
removed and replaced with a card that 
has a folder with the number 100 in it 
recorded by a camera from a different 
maker (100XXXXX, with XXXXX being 
the name of the maker) and then a 
picture is recorded.
When recording after selecting 
[NO.RESET] (P20) from the [SETUP] 
menu. (Pictures will be recorded to a 
new folder with a number sequential to 
the folder recorded to immediately 
before. By using [NO.RESET] on a card 
that does not contain folders or pictures, 
such as one just formatted, the folder 
number can be reset to 100.)
∫ About the PTP conection
If the OS is “Windows XP” or “Mac OS X”, 
you can connect in PTP mode if you set 
this unit to [
] mode and then connect to 
your PC.
• Pictures can only be read on the camera. 
They cannot be written to a card or 
deleted.
• When there are 1000 or more pictures on 
a card, the pictures may not be imported.
• Do not use any other USB connection 
cables except the supplied one.
• Do not disconnect the USB connection 
cable while [ACCESS] is displayed.
• If there are a lot of pictures on the built-in 
memory or a card, it may take time to 
transfer them.
100_PANA
101_PANA
999_PANA
DCIM
MISC
P1000001.JPG
P1000002.JPG
P1000999.JPG
100_PANA
1
2
3
≥Built-in memory
Card
VQT1C14ENG.book  82 ページ  2006年12月4日 月曜日 午後11時0分