Panasonic DMC-FX12 User Manual (en)

Download
Others
93
VQT1C14
[NOT ENOUGH SPACE ON BUILT-IN 
MEMORY]/[NOT ENOUGH MEMORY IN 
THE CARD]
There is no space left on the built-in 
memory or the card.
• When you copy pictures from the built-in 
memory to the card (batch copy), the 
pictures are copied until the capacity of 
the card becomes full.
[SOME PICTURES CANNOT BE 
COPIED]/[COPY COULD NOT BE 
COMPLETED] 
The following pictures cannot be copied.
• When a picture with the same name as 
the picture to be copied exists in the copy 
destination.
• Files not based on the DCF standard.
Moreover, pictures recorded or edited by 
other equipment may not be copied.
[BUILT-IN MEMORY ERROR
FORMAT BUILT-IN MEMORY?]
This message will be displayed when you 
formatted the built-in memory on a PC. 
Format the built-in memory on the camera 
again. (P80) The data on the built-in 
memory will be deleted.
[MEMORY CARD ERROR
FORMAT THIS CARD?]
The card format cannot be recognized by 
the camera. Format the card again with the 
camera after saving necessary data on a 
PC etc. (P80)
[PLEASE TURN CAMERA OFF AND 
THEN ON AGAIN]
This message appears when the camera is 
not operating properly. Turn the camera off 
and on. If the message persists, contact the 
dealer or your nearest Service Center.
[MEMORY CARD PARAMETER ERROR]
• Use a card compatible with this unit. 
(P5, 14)
• You can only use an SDHC Memory Card 
if using cards with 4 GB or more capacity. 
[MEMORY CARD ERROR
PLEASE CHECK THE CARD]
• An error has occurred accessing the card. 
Insert the card again.
[READ ERROR
PLEASE CHECK THE CARD]
An error has occurred reading the data.
Insert the card again. Make sure the card is 
inserted properly and then play back again.
[WRITE ERROR
PLEASE CHECK THE CARD]
An error has occurred writing the data.
Turn the camera off and remove the card. 
Insert the card again and turn the camera 
on. Make sure the camera is turned off 
before removing or inserting the card to 
avoid damage.
[MOTION RECORDING WAS 
CANCELLED DUE TO THE LIMITATION 
OF THE WRITING SPEED OF THE 
CARD]
• When you set the picture quality to 
[30fpsVGA] or [30fps16:9], we 
recommend using a High Speed SD 
Memory Card with “10MB/s” or greater 
displayed on the package.
• Depending on the type of SD Memory 
Card or SDHC Memory Card, motion 
picture recording may stop in the middle.
[A FOLDER CANNOT BE CREATED]
A folder cannot be created because there 
are no remaining folder numbers that can 
be used. (P82)
Format the card after saving necessary 
data on a PC etc. (P80)
If you execute [NO.RESET] in the [SETUP] 
menu after formatting, the folder number is 
reset to 100. (P20)
VQT1C14ENG.book  93 ページ  2006年12月4日 月曜日 午後11時0分