Panasonic DMC-FX12 User Manual (en)

Download
Others
94
VQT1C14
[PICTURE IS DISPLAYED FOR 4:3 TV]/
[PICTURE IS DISPLAYED FOR 16:9 TV]
• The AV cable is connected to the camera. 
Press [MENU/SET] if you want to delete 
this message at once.
• Select [TV ASPECT] in the [SETUP] 
menu if you want to change the TV 
aspect. (P20)
• This message also appears when the 
USB connection cable is connected to the 
camera only.
In this case, connect the other end of the 
USB connection cable to a PC or a printer. 
(P81, 83)
[PLEASE RE-CONNECT THE PRINTER.]
This message will be displayed if you 
change the mode dial to print mode [
while this unit and the PC are connected. If 
a printer is connected, change the mode to 
a mode other than [
] mode and then 
check that no data is being transferred. 
([ACCESS] appears on the LCD monitor of 
this unit while data is being transferred.)
[USB MODE CHANGED. PLEASE 
REMOVE THE USB CABLE.]
This message will be displayed if you 
change the mode dial to a mode other than 
print mode [
] while this unit and the 
printer are connected.
Set the mode dial to [
] again and then 
disconnect the USB cable. If printing, stop 
the printing and then disconnect the USB 
cable.
Troubleshooting
If you return the menu settings to the initial 
settings at the time of purchase, the 
condition may improve.
Select [RESET] in the [SETUP] menu. 
(P20)
∫ Battery and power source
1: The camera cannot be operated even 
when it is turned on.
• Is the battery inserted correctly?
– Check the direction of the battery. 
(P13)
• Is the battery sufficiently charged?
– Use a battery that has been 
sufficiently charged.
2: The LCD monitor turns off while the 
camera is turned on.
• Is power save mode (P18) or economy 
mode (P19) activated?
– Press the shutter button halfway to 
cancel these modes.
• Is the battery exhausted?
– Use a battery that has been 
sufficiently charged.
3: The camera turns off immediately 
after it is turned on.
• Is the battery charge insufficient to 
operate the camera?
– Use a battery that has been 
sufficiently charged.
– If you leave the camera on, the 
battery will be exhausted. Turn the 
camera off frequently by using power 
save mode (P18) etc.
∫ Recording
1: The picture cannot be recorded.
• Is the mode dial correctly set?
• Is there any memory remaining on the 
built-in memory or the card?
– Before recording, delete some 
pictures. (P30)
2: The recorded picture is whitish.
The lens is dirty.
• The picture can become whitish if there 
is dirt e.g. fingerprints on the lens. If the 
lens is dirty, turn on the camera, eject 
the lens barrel (P9) and gently wipe the 
lens surface with a soft dry cloth.
3: The recorded picture is too bright or 
dark.
• Check that the exposure is correctly 
compensated. (P40)
VQT1C14ENG.book  94 ページ  2006年12月4日 月曜日 午後11時0分