Panasonic WV-CW504F User Manual (en)

Download
24
Adjust the camera
z
   Be sure to view the monitor for adjustment when the camera angle is adjusted. 
    Connect the monitor for adjustment (e.g. a small LCD) to the monitor output connector, and 
adjust the camera angle. 
    When determining the camera angle, repeat fine follow the adjusting procedure of q, w, and 
e
 shown below. 
 
q
  Loosen the panning lock screw and rotate the camera head horizontally to adjust panning, 
and tighten the panning lock screw. 
 
w
  Loosen the tilting lock screws and rotate the camera head vertically to adjust tilting, and 
tighten the tilting lock screw. 
 
e
  Rotate the tilt adjusting table, and adjust the azimuth angle of the image. 
Important:
 •  The panning lock screw and the tilting lock screw shall be securely tightened.
    (Recommended tightening torque: 0.59 N·m {0.44 lbf·ft})
Note:
 •  The video output to the BNC connector will be interrupted while an adjusting monitor is con-
nected to the monitor output connector.
 •  At the same time for the pan and tilt adjustments, make focus adjustments of Step 2.
     
LO
C
K
 
LO
C
K
 
LO
C
K
 
LO
C
K
 
75 °
Tilting lock screw
Monitor output connector 
(RCA)
Tilt adjusting table
Panning lock screw
Panning table