Panasonic WV-CW504F User Manual (en)

Download
27
b
   Mount the enclosure and inner 
dome. 
    Tighten  the  screws  that  have  been  loos-
ened in Step 2 in page 23 using the sup-
plied driver bit.
    (Recommended tightening torque:  
0.78 N·m {0.58 lbf·ft})
Important:
 •  Attach the inner dome in accordance with
the lens direction to not to change the lens 
direction. 
 •  Check  if  the  tabs  of  the  inner  dome  are
firmly fit. 
 •  Remove  the  cushioning  (pink  sheet)  from
the inside of the dome and the protection 
sheet from the outside of the dome.
Note:
 •  Defocus may be caused by the reinstalled enclosure. When using a system controller (option),
adjust the back-focus on the setup menu after attaching the enclosure. (+ Operating Instruc-
tions (PDF))
 •  When not using a system controller, by using the [ABF2] button back-focus adjustment is avail-
able after attaching the enclosure. The procedure for the use of the [ABF2] button is as speci-
fied below. 
 
q
  Press the [ABF2] button. → The ABF operation indicator will start blinking. 
 
w
  While the indicator is blinking (for around 3 minutes), attach the enclosure to the camera. 
 
e
  When the indicator changes to steady light, back-focus will be adjusted automatically. After 
the back-focus is adjusted, the indicator will go out. 
 
*  Do not aim the camera to objects continuously moving. 
 
*  If the indicator blinks again after changing to steady light, back-focus adjustment may have 
failed. In this case, check the back-focus on the LCD monitor. 
 
  To adjust the back-focus again, perform Step q to e again. 
     
Cutout for 
mounting 
Groove for 
mounting