Netopia 3346N-ENT User Guide (en)

4-22  Firmware User Guide
Binding Map Lists and Server Lists
Once you have created your map lists and ser ver lists, for most Netopia Router models you must bind them to 
a profile, either a Connection Profile or the Default Profile. You do this in one of the following screens:
screen (see below) of the Connection Profile configuration menu
) of the Default Profile configuration menu
IP profile parameters
To bind a map list to a Connection Profile, from the Main Menu go to the WAN Configuration screen then the 
Display/Change Connection Profile screen. From the pop-up menu list of your Connection Profiles, choose the 
one you want to bind your map list to. Select IP Profile Parameters and press Return.
The IP Profile Parameters screen appears.
Select NAT Map List and press Return. A pop-up menu displays a list of your defined map lists.
IP Profile
Connection Profile
                            IP Profile Parameters
         Address Translation Enabled:       Yes
         IP Addressing...                   Numbered
         NAT Map List...                    Easy-PAT List
         NAT Server List...                 Easy-Servers
         NAT Options...
         Stateful Inspection Enabled:       No
         Local WAN IP Address:    
         Local WAN IP Mask:       
         Remote IP Address:       
         Remote IP Mask:          
         Filter Set...
         Remove Filter Set
         RIP Profile Options...
Toggle to Yes if this is a single IP address ISP account.
Configure IP requirements for a remote network connection here.