Netopia 3346N-ENT User Guide (en)

Download
10-30  Firmware User Guide
Note:
There are two groups of items in this screen, one for input filters and one for output filters. In this 
section, you’ll learn how to add an input filter to a filter set. Adding an output filter works exactly the same way, 
providing you keep the different source and destination perspectives in mind.
1.
To add a filter, select Add Input Filter to Filter Set and press Return. The Add Input Filter screen appears.
2.
To make the filter active in the filter set, select Enabled and toggle it to Yes. If Enabled is toggled to No, the 
filter can still exist in the filter set, but it will have no effect.
                              Display/Change Filter Set...
         Filter Set Name:                   Filter Set  3
                     Add Input Filter to Filter Set...
                     Display/Change Input Filter...
                     Delete Input Filter...
                     Move Input Filter...
                     Add Output Filter to Filter Set...
                     Display/Change Output Filter...
                     Delete Output Filter...
                     Move Output Filter...
                               Add Input Filter
         Enabled:                           Yes
         Forward:                           No
         Source IP Address:                 0.0.0.0
         Source IP Address Mask:            0.0.0.0
         Dest. IP Address:                  0.0.0.0
         Dest. IP Address Mask:             0.0.0.0
         Protocol Type:                     ANY
         Protocol Type:                     TCP
         Source Port Compare...             No Compare
         Source Port ID:                    0
         Dest. Port Compare...              No Compare
         Dest. Port ID:                     0
         Established TCP Conns. Only:       No
         ADD THIS FILTER NOW                CANCEL