Canon EOS 1DS MARK II 9443A009 Instruction Manual (en)

Download
162
If there is a problem, first refer to this Troubleshooting Guide. 
¡
You are using the wrong battery. 
s
Use the dedicated Ni-MH Pack. (p.18)
¡
The battery is not properly attached to the charger. 
s
Attach the battery properly to the charger. (p.18)
¡
The battery is exhausted. 
s
Recharge the battery. (p.18)
¡
The battery is not installed properly. 
s
Install the battery properly. (p.20)
¡
The memory card slot is open. 
s
Push in the memory card and close the memory card slot. (p.24)
¡
If you set the <
4
> switch to <
2
> right after shooting, the 
access lamp will still light or blink for a few seconds while the 
image is recorded onto the memory card. 
s
When the camera finishes recording the image to the memory 
card, the access lamp will stop blinking and the power will turn off. 
¡
The battery is not fully charged. 
s
Recharge the battery fully. (p.18)
¡
The battery’s service life has expired. 
s
Replace it with a new battery. (p.168)
Troubleshooting Guide
Power Source
The battery cannot be recharged.
The camera does not operate even when the <4> switch is set to <1>.
The access lamp lights or blinks even when the <4> switch is set to <2>.
The battery becomes exhausted quickly.