Sanyo VPC-CA102 User Manual (en)

English

i This camera’s internal battery serves to maintain the date and time 

settings, as well as the shooting settings. The backup battery will be fully 
charged when the battery pack is kept in the camera continuously for about 
2 days. In the fully charged state, the backup battery will maintain the 
camera settings for about 7 days.

i A small amount of power is still used even if the camera is turned off, and it 

is therefore recommended that the battery pack be removed from the 
camera if it is not going to be used for a long time. Note that when the 
battery pack is removed for a long period, the time and date settings may 
be cleared. Before using your camera again, be sure to confirm that the 
camera settings are correct.

i The battery can be recharged while the camera is connected to a 

computer. During recharging, the camera is recognized by the computer as 
a separate drive; however, data cannot be exchanged.

i The time it takes to recharge will differ depending on the operating 

condition of the camera and the computer.

i Connect the dedicated USB interface cable to the USB connector on your 

computer. Do not connect it to the USB connector on the monitor or the 
keyboard, or to the USB hub. Correct operation of the USB interface cable 
cannot be guaranteed if it is connected to a connector other than the 
computer's USB connector.

i If the camera is not going to be used for an extended period of time, please 

disconnect the dedicated USB interface cable from the camera.